Home Rail News Wire-free trams

Wire-free trams

The new Dubai Al Sufouh Tramway will open on 11 November. Sheikh Mohammed bin Rashid Al Maktoum, UAE Vice President and ruler of Dubai, confirmed the official launch date following a test run on the first section of the new network.

Dubai’s tram system will be the first in the modern era to run exclusively catenary-free. The 14.6-kilometre network utilises Alstom’s APS II system (Alimentation par le Sol), an updated version of the one which was first used on Bordeaux’s tram in 2003.

A third rail is buried centrally between the two running rails, exposing only the top surface at ground level. This rail is divided into short insulated sections and only those actually under the tram at any one time are energised. Thus, pedestrians and pets can safely walk on exposed sections of the track without fear of electrocution.

Up until now, the system has been used on relatively short stretches of track to run through areas where unsightly overhead wires would not be welcome. Thus, the Bordeaux system has a total of 12km of APS out of a total network length of 43.3km.

However, Dubai is the first network to run without wires at all. Services on the 14.5 kilometre route will be run using Alstom Citadis 402 trams, each 44 metres long and with a capacity of 408 passengers. Interestingly, all of the stations will be fitted with platform screen doors, another first for a tram system.

Nigel Wordsworth BSc(Hons) MCIJ
Nigel Wordsworth BSc(Hons) MCIJhttp://www.railengineer.co.uk
SPECIALIST AREAS Rolling stock, mechanical equipment, project reports, executive interviews Nigel Wordsworth graduated with an honours degree in Mechanical Engineering from Nottingham University, after which he joined the American aerospace and industrial fastener group SPS Technologies. After a short time at the research laboratories in Pennsylvania, USA, Nigel became responsible for applications engineering to industry in the UK and Western Europe. At this time he advised on various engineering projects, from Formula 1 to machine tools, including a particularly problematic area of bogie design for the HST. A move to the power generation and offshore oil supply sector followed as Nigel became director of Entwistle-Sandiacre, a subsidiary of the Australian-owned group Aurora plc. At the same time, Nigel spent ten years as a Technical Commissioner with the RAC Motor Sports Association, responsible for drafting and enforcing technical regulations for national and international motor racing series. Joining Rail Engineer in 2008, Nigel’s first assignment was a report on new three-dimensional mobile mapping and surveying equipment, swiftly followed by a look at vegetation control machinery. He continues to write on a variety of topics for most issues.

LEAVE A REPLY

Please enter your comment!
Please enter your name here

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Must Read

Geophysical consultancy Zetica expands with help from HSBC UK

Zetica, the engineering and environmental geophysics consultancy, has renovated a 21,500 sq.ft. building to accommodate up to 80 staff, as well as provide additional...

Birmingham: Washwood Heath train factory demolished

The former Alstom factory at Washwood Heath, Birmingham, where Virgin’s Pendolinos were built, has been demolished to make way for an HS2 maintenance depot.

Barnehurst cutting reopened after landslip closes the Bexleyheath line for a week

The cutting at Barnehurst, on the Bexleyheath line between Lewisham and Dartford, Kent, reopened on Monday 18 February after being closed for a week.

West Coast main line reopens after lorry strikes bridge

Network Rail has reopened the West Coast main line through the Stafford area after more than 24 hours of disruption caused by a...

UGL Unipart JV wins Sydney contract extension worth AU$395m

UGL Unipart, a 70:30 joint venture between UGL, a member of CIMIC Group, and Unipart Rail, has been awarded a two-year extension to its...